How to edit gcode? - Is it possible to salvage a job by restarting after a jammed extruder? - Snapmaker 2.0 - Snapmaker: where creation happens

Stepped away for a bit, glad you’re making some progress! Yea, the G92 command is a way to set an arbitrary reference point for future commands. It sounds like you got it, but I’ll just reiterate: that G92 E0->G92 E115.7035 change was because over, say, 1000 lines of gcode 115mm of filament was extruded, and if I don’t change the reference as soon as the first G1 X Y E116 is executed it’ll extrude 116mm of filament. So you have to tell the machine that it’s starting at 115.7 so it extrudes 0.3

GUIDE] Setting up the Neptune 4 Pro with Cura 5.4 : r/ElegooNeptune4

Luban V4.5: Known Issues & Corresponding Solutions - Snapmaker

What are the rules of thumb with various calibration and 3D print

Dual extruder calibration example - Snapmaker 2.0 - Snapmaker

Issues with generating g-code? - Getting Started - Snapmaker

Dual Extruder Problems & Gripes Mega Thread - Snapmaker 2.0

Unable to configure SM2A350 with Dual Extruder in Cura. What am I

Bed Leveling/Adhesion Issues for the Dual Extruder - Snapmaker 2.0

Dual extruder calibration example - Snapmaker 2.0 - Snapmaker

GUIDE] Setting up the Neptune 4 Pro with Cura 5.4 : r/ElegooNeptune4

3D Printer Under extrudes or not at all - #19 by MakariAeron

Dual extruder calibration example - Snapmaker 2.0 - Snapmaker

3D Printer Nozzle Jam: Main Causes and Cleaning Methods – Snapmaker

Snapmaker 2.0 Review — CNC Kitchen

GUIDE] Setting up the Neptune 4 Pro with Cura 5.4 : r/ElegooNeptune4