BUG] Additional retract when linear advance is on. · Issue #19982

i have problem on 0.2 mm nozzle and 0.1 mm layer height. Marlin.zip Marlin 2.0.7.1 And I tried to fix this problem, which worked properly by deleting the original retract, but then it crashed due to other retractions. the slicer is cura

NLX-25 556 Linear Compensator - Next Level Arms

This is my first print after calibrating linear advance. Can anyone tell me what's going on here? Looks kind of underextruded but only at the spots where the nozzle has to retract : r/ender3v2

Solved When A is invertible, the linear system Ax=b has a

BUG] Bulge on linear advance speed change · Issue #16880 · MarlinFirmware/Marlin · GitHub

BUG] Rapid changes of acceleration break linear advance when using Junction Deviation · Issue #15473 · MarlinFirmware/Marlin · GitHub

PDF] Takeoff Obstacle Clearance Procedures: The Feasibility of Extended Second Segment Climb

Bug in Linear Advance 1.5, causes extruder motor to stop for several seconds · Issue #11711 · MarlinFirmware/Marlin · GitHub

Bug in Linear Advance 1.5, causes extruder motor to stop for several seconds · Issue #11711 · MarlinFirmware/Marlin · GitHub

Show that the vectors v1, v2, and v3 are linearly dependent [ Linearly Independent ]

This is my first print after calibrating linear advance. Can anyone tell me what's going on here? Looks kind of underextruded but only at the spots where the nozzle has to retract