Z offset issues – PrusaSlicer – Prusa3D Forum

Hi, I switched from cura to prusaslicer and ran into strange issues with z offset. I have matched the machine config, pre-code, and post-code in bot

Stringing with prusaslicer solved with Cura – How do I print this

Avoid Crossing Perimeters creates travel moves on top of

Issues with printing file – How do I print this? (Printing help

Prusa MK4 Review: Return of the King (Updated)

Any way to change the Z Offset? – Hardware, firmware and software

Report a little bug on PrusaSlicer 2.4 with Z offset – PrusaSlicer

PrusaSlicer loves to print in the air : r/prusa3d

Hot End Moves to the back and bottom left after a print

Z height offsets for random layer - prints mid air then resumes at

Under extrusion (?) during first layer infill. 215 print temp

Prusa Slicer 2.6 - Organic Supports, Embossing and More!

Releases · prusa3d/Prusa-Firmware-Buddy

Klipper and PrusaSlicer getting into fight over Z offset? : r/klippers

First layer looks good via first layer calibration but when I