Temperature Drops after Print Starts - AO-101 & AO-100 - LulzBot

Hey Guys, So I had to put in new thermistor recently, did some other structural changes (60mm height increase) and wired in a fan which isn’t currently connected. Yet now I am getting this issue with my hotend where once the print start the temperature drops even though it looks like the extruder is still rocking it. I ran PID autotune, stored the values, brought the bed and then the hotend up too 230C using Repetier. Then I dropped in the GCODE. You can see down below the temperature curve. T

LulzBot Mini Review: Compact, Powerful Yet Easy to Use

Can't wait explore the world of 3D printing with my Christmas gift! Is there anything I should know that not a lot of people talk about? : r/3Dprinting

3D Printing Troubleshooting Guide

Mosaic Palette Users Gcode at the end of print to retract 100mm

Review: LulzBot Mini 3D Printer - Make

LulzBot Mini 2 Review

Taz Workhorse fails to maintain nozzle temp during printing - LulzBot TAZ - LulzBot

Flash printer - AO-101 & AO-100 - LulzBot

Temperature Drops after Print Starts - AO-101 & AO-100 - LulzBot

Flash printer - AO-101 & AO-100 - LulzBot