Fusion 360 Sinumerik 840D post - TRAORI Disable - Autodesk Community - Fusion 360

Hello   I have a part that i want to machine with rotary toolpath but my sinumerik post will post TRAORI - but my control throws an error with i get to that command.   I wanted just to do it without it and just X Y Z A g codes - my origin is in the center of the rotary.   I have been searching but the post if found about disabling TRAORI dident work for me.    Any help is appriciated    

Fusion 360 CAM Users

Autodesk Fusion 360 problems - General Forum - VEX Forum

Solved: Post Procesor for siemens 840d, the 4th axis - Autodesk Community - Fusion 360

Solved: Optimize thread milling - Autodesk Community - Fusion 360

Autodesk Fusion 360 Drawings October Update

Solved: Siemens 4th axis, wrapped toolpath, erratic feed rates issue - Autodesk Community - Fusion 360

Sinumerik 840D Post Outputs Wrong Values for MCALL Type 84 Cycle - Autodesk Community - Fusion 360

Fusion 360 Sinumerik 840D post - TRAORI Disable - Autodesk Community - Fusion 360

Fusion 360 Development Update: Manufacturing (2021) - Fusion 360 Blog

Fusion 360 Help, Turning basics, Setup

Fusion 360 Sinumerik 840D post - TRAORI Disable - Autodesk Community - Fusion 360

Rotary Module with Fusion360: It works! (good enough) - Snapmaker 2.0 - Snapmaker: where creation happens

Fusion 360 CAM - How to use the remaining stock from the previous setup