BUG] Additional retract when linear advance is on. · Issue #19982 · MarlinFirmware/Marlin · GitHub

i have problem on 0.2 mm nozzle and 0.1 mm layer height. Marlin.zip Marlin 2.0.7.1 And I tried to fix this problem, which worked properly by deleting the original retract, but then it crashed due to other retractions. the slicer is cura

BUG] Linear Advance K Calibration Print stops extruding · Issue

BUG] Bulge on linear advance speed change · Issue #16880

Collecting ideas and advises for LIN_ADVANCE v2 · Issue #9048

bugfix-1.1.x] Marlin (Linear Advance) produces blobs on 90

BUG] [Bugfix 2.0.x] TMC2209 + Linear advance = Line stair for the

Bug in Linear Advance 1.5, causes extruder motor to stop for

BUG] Rapid changes of acceleration break linear advance when using

QUESTION] LIN_ADVANCE 1.5 -- extruder rattles *a lot*. · Issue

Linear Advance bug — occasional backwards motion · Issue #9816

BUG] Motor stuttering with linear advance on TMC2208 since Marlin

TX data loss · Issue #26507 · MarlinFirmware/Marlin · GitHub

Problems with Linear Advance · Issue #5222 · MarlinFirmware/Marlin

Bug in Linear Advance 1.5, causes extruder motor to stop for

BUG] Linear advance: actual extruder acceleration slower than